Nec 2000 Instrukcja Użytkownika Pobierz pdf (Strona 86)

4-10 Adding Expansion Devices

Locate an empty module slot. If you need to remove one or both

modules, see “Removing a SO-DIMM Module” in the next section.

Before you install a SO-DIMM, reduce static

discharge by touching a metal part on the system unit.

Install the SO-DIMM module as follows (see the following figure).

! Align the notch in the module with the key in the empty slot.

! Hold the module at a 45-degree angle and insert it into the slot.

! Firmly push the module into the socket.

! Press down on the edge of the module until the plastic retaining

clips snap into place.

Installing the SO-DIMM module

A – SO-DIMM Module C – Socket Key

B – Notch D – Plastic Retaining Clip (2)

Install the SO-DIMM module panel and retaining screw.

10.

Plug in the AC adapter power cord and press the power switch.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 136 137

Brak uwag

Nec 2000 Instrukcja Użytkownika Strona 86