NEC Express5800/S110R-1 Podręcznik Użytkownika Pobierz pdf (Strona 111)

Appendix D: Adaptec HostRAID Setup Guidelines

D-1

Appendix D

Adaptec HostRAID Setup Guidelines

After all the hardware has been installed, you must ﬁ rst conﬁ gure the Adaptec Embedded

SATA RAID before you install the Windows operating system. The necessary drivers

are all included on the bootable CDs that came packaged with your serverboard.

Note: The following section provides information on the Adaptec SATA RAID Driver

based on the Intel ICH7R South Bridge Controller.

D-1 Introduction to the Intel ICH7R I/O Controller Hub

Located in the South Bridge of the Intel 3010 Chipset, the ICH7R I/O controller

hub provides the I/O subsystem with access to the rest of the system. It supports

a single-channel Ultra ATA/100 Bus Master IDE controller (PATA) and an Adaptec

SATA Host controller, which supports up to six Serial ATA drives, up to two RAID

volumes and up to four drives in RAID conﬁ gurations. (See the table below for

details.)

aid Level Create Via When Appropriate

AID 0 Quick Init Creating a RAID 0 on new drives

AID 0 Migrate* Creating a RAID 0 from one new drive and

one drive with data you wish to preserve

AID 1 Build* Any time you wish to create a RAID 1, but especially if

you have data on one drive that you wish to preserve

AID 1,

AID 10

Clear Creating a RAID 1 or RAID 10 on new drives, or when

you want to ensure that the array contains no data after

creation.

AID 1,

AID 10

Quick

Init Fastest way to create a RAID 1 or RAID 10

Appropriate when using new drives

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 133 134

Brak uwag

NEC Express5800/S110R-1 Podręcznik Użytkownika Strona 111