
Linux Setup 4-11
4. Use the following command to check the status of LAN card.
>vndctl status 7
You can check the status of the slot 7 using vndctl.
“ha0” indicates the interface name (ha0) which is used to set dual configuration to the two
LAN cards and then virtually treat them as one LAN card, and their setting values. The
descriptions under “ha0” are values set for two LAN cards.
--Virtual Network Status--
virtual status ipconf slot real(s)
ha0 OKAY no 7 *epro01.06 epro40.06
Link encap:Ethernet HWaddr 00:30:13:F1:E9:7D
BROADCAST MASTER MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
slot real status link
7 left epro01.06 DOWN
Link encap:Ethernet HWaddr 00:30:13:F1:E9:7D
BROADCAST SLAVE MTU:1500 Metric:1
RX packets:12242 errors:0 dropped:0 overruns:0 frame:0
TX packets:129 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:946021 (923.8 Kb) TX bytes:6876 (6.7 Kb)
Interrupt:47 Base address:0xb000
right epro40.06 DOWN
Link encap:Ethernet HWaddr 00:30:13:F1:E9:7D
BROADCAST SLAVE MTU:1500 Metric:1
RX packets:125 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:8928 (8.7 Kb) TX bytes:0 (0.0 b)
Interrupt:19 Base address:0xd000
5. Use the following command to make settings of the dual LAN card configuration of the
slot 7.
>vndctl config 7
The screen will be switched to the entry screen. (netconfig command is being executed.)
The message “Would you like to set up networking?” will appear. Click “Yes” to continue.
Specify whether you use DHCP or not, and IP addresses, etc., depending on the operating
environment.
6. Use the following command to activate the dual LAN card configuration of the slot 7.
>vndctl up 7
Komentarze do niniejszej Instrukcji