NEC SigmaBlade B140a-T Podręcznik Użytkownika Pobierz pdf (Strona 343)

100

101

Installing the Operating System B-45

9. On the [Paging file size for each drive] box, specify as follows:

– A value larger than the recommended size shown in [Total paging file size for all

drives] for [Initial size]

– A value larger than the [Initial size] for [Maximum size]

Then click [Set].

IMPORTANT:

 The above-mentioned paging file size is recommended for collecting

debug information (memory dump). The paging file with initial size

large enough to store the dump file in the boot drive is required.

Correct debug information might not be able to be collected due to

virtual memory shortage when the paging file is insufficient, so set

an enough size of the paging file with the entire system.

 For more information on "Recommended" value, see "About the

System Partition Size" described earlier.

 In case the memory is expanded, re-specify the paging file to suit the

new memory size.

10. Click [OK].

The message to restart the system may appear according to the modified specification.

In such case, follow the message to restart the system.

1 2 ... 338 339 340 341 342 343 344 345 346 347 348 ... 375 376

Komentarze do niniejszej Instrukcji

Brak uwag

NEC SigmaBlade B140a-T Podręcznik Użytkownika Strona 343

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Serwery NEC SigmaBlade B140a-T