NEC Express5800/GT110e-S Przewodnik Instalacji Pobierz pdf (Strona 251)

7. Setup for Solving Problems

Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)

251

Chapter 1 Installing Windows

9. In the Paging file size for each drive group box, specify as follows:

For the Initial size text box, specify a value equal to or greater than the Recommended value shown in

the Total paging file size for all drives area.

For the Maximum size text box, specify a value equal to or greater than the value specified in the Initial

size text box.

After specifying the above values, click [Set].

Note the following when specifying a paging file size.

• The above paging file sizes are recommended for collecting debug information (dump file).

The initial size of the boot volume paging file must be large enough to store dump files.

Make sure to set a sufficient paging file size. If the paging file size is insufficient, correct

debug information might not be able to be collected due to a shortage of virtual memory.

• For details about the Recommended value in the Total paging file size for all drives area,

refer to System partition size in Before Starting Setup.

• When memory is added, re-specify the paging file according to the increased memory size.

10. Click [OK].

The message to restart the system appears depending on the modifications made.

In this case, restart the system.

Specification of the memory dump settings is now complete.

1 2 ... 246 247 248 249 250 251 252 253 254 255 256 ... 274 275

Brak uwag

NEC Express5800/GT110e-S Przewodnik Instalacji Strona 251