NEC Express5800/R120f-1M Przewodnik Instalacji Pobierz pdf (Strona 226)

5. Setting Up Windows Server 2008 R2

Express5800/R120f-1M, R120f-2M Installation Guide (Windows)

226

Chapter 1 Installing Windows

(2) Setting up team

1. Open the Device Manager.

2. Open Network adapters, and then the Intel(R) xxx properties.

3. On the Teaming tab, select the Team this adapter with other adapters check box.

Click New Team.

4. Type the name of the team in Specify a name for the team and click Next.

5. Select an adapter to be included in the team, and then click Next.

6. Select a team type, and then click Next.

7. Click Finish.

The properties of the selected team appears.

8. On the Settings tab, click Modify Team button.

9. Perform the following procedure to set the team member adapter priority status.

― Set Primary

Select the adapter and click Set Primary.

― Set Secondary

Select the adapter and click Set Secondary.

When primary and secondary adapters are specified, click OK to close the window.

Tips

Adapter priority can be confirmed by the following procedure:

1) Click Settings tab in team adapter properties.

2) Confirm Primary/Secondary specified for each adapter in Team list.

10. On the Settings tab, click Test Switch. Click Run test on the Test Switch screen.

Test completes when a message indicating successful operation is displayed.

If you are using SFT (Switch Fault Tolerance), go to Step 11 because Test Switch is not supported.

Note

Before running the test, confirm whether the adapter status is "Active" or "Standby"

on the Settings tab. If any error is displayed, read the message and change the

setting of the switching hub.

Also make sure that all adapters in team are linked up.

Important

Even if the test result is correct, the message below may appear.

Check the setting of the switching hub (L2) port. If no problem is found,

ignore the message.

"The switch is configured with aggregated ports, but the team

type does not support port aggregation. The switch is configured

with VLAN tagging, but the team has no VLANs."

"Reconfigure the switch for link aggregation, or disable VLAN

tagging on the switch."

11. Restart the system.

1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 343 344

Komentarze do niniejszej Instrukcji

Brak uwag

NEC Express5800/R120f-1M Przewodnik Instalacji Strona 226

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Serwery NEC Express5800/R120f-1M