NEC GammaCompMD QA Instrukcja Użytkownika Pobierz pdf (Strona 141)

GammaCompMD QA Client User Manual

7.7.3.5. Create Modification Log Entry

When Create Modification Log Entry is clicked in Administrator, the Create Modification Log

Entry dialog box, as shown in Figure 128, is displayed. Enter any text (such as “change

display” or “execute calibration”) in the input field. The entered log name is shown as an

Event in the Log Viewer (Level: Modification Log, Original: Operator).

Figure 128: Create Modification Log Entry dialog box

Input field Up to 127 Upper case or lower case alphanumeric characters or

special characters (%, #, *, @, etc.) are valid.

OK button Saves the settings and closes the dialog box. The OK button cannot

be clicked unless any character is entered in the input field.

Cancel button Closes the dialog box without saving any settings.

7.7.3.6. Display Control Button Lock

When you click on Display Control Button Lock in Administrator, the Display Control Button

Lock dialog box is displayed, as shown in Figure 129. This function is used to lock the buttons

which are used to control the On-Screen-Display (OSD) function of a display. Locking the

buttons of a calibrated display is very essential to prevent any changes of the display

characteristics from intended or unintended tampering.

Displays other than those made by NEC, and displays where the Interface Mode is set as

StdDisplay or NAVDisplay, cannot be selected. Also the NEC models MD212G3, MD205MG,

MD205MG-1, MD215MG, MD211G5 and MD302C6, as well as NEC Large Format Displays

are not selectable, because they do not support the Display Control Button Lock function.

Please refer to the list 1.7 Supported Display Models (page 11).

NOTE: If one of the Lock commands is set, it will be only applied after the calibration is

complete. The Lock settings will not be applied if the calibration fails. If Do not lock control

buttons is set, any Lock is released when the calibration starts.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 181 182

Brak uwag

NEC GammaCompMD QA Instrukcja Użytkownika Strona 141